Compaq Deskpro 2000 User Manual Page 145

  • Download
  • Add to my manuals
  • Print
  • Page
    / 269
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 144
Compaq Deskpro 2000 Series of Personal Computers 6-3
6.3 Preparation for Disassembly
See Chapter 4, “Removal and Replacement Preliminaries,” for initial procedures.
To prepare the computer for disassembly, complete the following steps:
1. Remove any diskette, compact disc, or tape from the computer.
2. Turn off the computer and any peripheral devices that are connected to it.
CAUTION:
Turn off the computer before disconnecting any cables.
3. Disconnect the power cord from the electrical outlet and then from the computer.
4. Disconnect all peripheral device cables from the computer.
During disassembly, label each cable as you remove it, noting its position and routing.
Keep all screws with the unit removed.
CAUTION:
The screws used in the computer are of different thread sizes and lengths; using the wrong
screw in an application may damage the unit.
6.4 Feet
Four rubber feet are mounted to the underside of the chassis. If necessary, remove the old feet and
scrape the residue of the old feet from the chassis using a small, flat-bladed screwdriver. To attach
replacement feet to the chassis, remove the protective strip from the adhesive on the back of the new
feet and press them into place.
Figure 6-2.
Installing the Feet
Page view 144
1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 268 269

Comments to this Manuals

No comments