Compaq 4000N User Manual download pdf (Page 100)

Chapter 5 Input/Output Interfaces

Compaq Deskpro 4000N and 4000S Personal Computers

First Edition – September 1997

5-10

5.3 DISKETTE DRIVE INTERFACE

The diskette drive interface supports up to two diskette drives through a standard 34-pin diskette

drive connector. All Deskpro 4000S models include a 3.5 inch 1.44-MB diskette drive installed

as drive A. There is no physical provision for a second drive (B).

The diskette drive interface function is integrated into the 87307 I/O controller component. The

internal logic of the I/O controller is software-compatible with standard 82077-type logic. The

diskette drive controller has three operational phases in the following order:

♦ Command phase - The controller receives the command from the system.

♦ Execution phase - The controller carries out the command.

♦ Results phase - Status and results data is read back from the controller to the system.

The Command phase consists of several bytes written in series from the CPU to the data register

(3F5h/375h). The first byte identifies the command and the remaining bytes define the

parameters of the command. The Main Status register (3F4h/374h) provides data flow control

for the diskette drive controller and must be polled between each byte transfer during the

Command phase.

The Execution phase starts as soon as the last byte of the Command phase is received. An

Execution phase may involve the transfer of data to and from the diskette drive, a mechnical

control function of the drive, or an operation that remains internal to the diskette drive controller.

Data transfers (writes or reads) with the diskette drive controller are by DMA, using the DRQ2

and DACK2- signals for control.

The Results phase consists of the CPU reading a series of status bytes (from the data register

(3F5h/375h)) that indicate the results of the command. Note that some commands do not have a

Result phase, in which case the Execution phase can be followed by a Command phase.

During periods of inactivity, the diskette drive controller is in a non-operation mode known as

the Idle phase.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 195 196

No comments

Compaq 4000N User Manual Page 100