Compaq 4000N User Manual download pdf (Page 137)

Technical Reference Guide

Compaq Deskpro 4000N and 4000S Personal Computers

First Edition - September 1997

7-3

7.2.2 POWER CONTROL

The power supply assembly is controlled digitally by the PS On signal (Figure 7-1). When PS On

is asserted (high), the Power Supply Assembly is activated. When PS On is de-asserted, the

Power Supply Assembly (and the rest of the system) is off. The PS On signal is typically

controlled through the Power Button, which can be set by software (Windows 95) to operate as

either a standard On/Off button or as a Suspend button. The resultant action of pressing the

power button depends on the programmed state of the power button.at that time and is described

as follows:

System State Pressed Power Button Results In:

Off Negative pulse, of which the falling edge results in power control logic asserting

PS On signal to Power Supply Assembly, which then initializes. Four-second

counter is not active.

On,

Advd. Power Disabled

Negative pulse, of which the rising edge causes power control logic to de-assert

the PS On signal. Four-second counter is not active.

On,

Advd. Power Enabled

Pressed and Released Under Four Seconds:

Negative pulse, of which the falling edge causes power control logic to

generate SMI-, set a bit in the SMI source register, set a bit for button status,

and start four-second counter. Software should clear the button status bit

within four seconds and the Suspend state is entered. If the status bit is

not cleared by software in four seconds PS On is de-asserted and the

power supply assembly shuts down (this condition is meant as a guard in

case the OS is hung).

Pressed and Held At least Four Seconds Before Release:

If the button is held in for at least four seconds and then released, PS On is

negated, de-activating the power supply.

The PS On signal can also be activated with a power “wake-up” of the system due to the

following events:

Magic Packet - If the network interface controller is enabled for remote wake-up, reception of a

“Magic Packet” results in the NIC component asserting the PINTA- signal to the power control

logic, which in turn asserts the PS On signal and turns on the power supply assembly.

RTC Alarm/Modem Ring - These events (within the 87307 I/O controller) are programmable for

power wake-up and can affect the assertion of the PS On signal through the power control logic.

NOTE:

The PS On signal can be configured to be asserted whenever the power supply

assembly is connected to live AC by setting DIP SW1 position 6 to the “On” (closed or

grounding) position. This condition overrides all other settings.

The power LED is normally on in a steady state with the system on. When the system is in a low

power (suspend) condition the power LED is pulsed, causing it to blink at approximately a rate of

1-Hz. The blinking is affected through the power control logic

The power button can be inhibited by invoking BIOS call INT 15, AX=E828h, which is

discussed in Chapter 8, “BIOS ROM.”

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 195 196

Comments to this Manuals

No comments

Compaq 4000N User Manual Page 137

Comments to this Manuals

Related products and manuals for Computers Compaq 4000N