2-34 Compaq ProLiant 8500 Server Maintenance and Service Guide
I/O Module
The I/O module is located at the rear of the server. Remove it to replace or service
non-hot-pluggable components or to access other components in the I/O module.
Removing the I/O Module from Tower Model Servers
To remove the I/O module:
1. Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2. Open the top access panel. See “Top Access Panel” earlier in this chapter.
3. Loosen the shipping screw, if necessary. See “Shipping Screw” earlier in this chapter.
4. Push in on the sides of the stop latches on the I/O module, and rotate the cam levers
downward
.
5. Pull the I/O module out of the chassis until it catches on the module stop latch.
1
3
2
Figure 2-25. Partially removing the I/O module
Comments to this Manuals